View Single Post
  #17  
Old 06-17-2007, 04:25 PM
Lynn Erickson Lynn Erickson is offline
EVOLUTION EZE
 
Join Date: Nov 2005
Location: Chino, CA
Posts: 535
Default Re: Seatback top done (sort of)

Quote:
Originally Posted by Erick View Post
I thought this might be a good place to ask a question about micro. How much should I be applying to the surface of the lay-up? Should it be scraped completely off the part then apply the glass or left thicker? Is it supposed to completely fill the pores of the low density foam?

Chapter 7
Micro should be used as dry as practical. it is used to fill the foam pores and small voids under the glass layup. it is lighter than straight resin that would fill the pores if the micro was not used. it weights about the same as the foam so it can be used to improve the foam shape to allow the glass to lay smooth over the surface. if the foam shape is good then you only put on enough to fill the pores
__________________
This is my opinion of these facts and only my opinion, your opinion may vary

Lynn Erickson A&P for lets say almost 30 years
Much better with a Dremel than a computer.
What if they gave me choice between a fast computer or a fast plane?
Reply With Quote